Elenco Surface Mount Generator Kit Manuale Utente

FUNCTION GENERATOR KITMODEL FG-600KAssembly and Instruction ManualCopyright © 2014, 1999 by ELENCO®All rights reserved. Revised 2014

-9-FINAL ASSEMBLYFigure K! Fit the PC board assembly into the topcase, making sure that all switches andpots come through the holes

-10-! Remove the backing from each rubber foot andplace them in the locations shown in Figure M.! Assemble the top and bottom case sections and

-11-TROUBLESHOOTING GUIDEA) NO SINE/TRIANGLE OR SQUARE WAVE OUTPUT1) Check the soldering on switch S3.2) Check the soldering on IC U1.3) Check for +9V

-12-FUNCTIONAL DESCRIPTIONThe FG-600 is a function generator integrated circuit capable of producing high quality sine, triangle, andsq

-13-CONTROLSRANGE SWITCHESSix ranges of frequency are provided by the range switch as shown in Table 1.Table 1POSITION TYPICAL FREQUENCY RANGE1 1Hz -

-14-Space War GunK-10Rapid fire or single shot with 2flashing LEDs.0-15V Power SupplyK-11A low-cost way to supplyvoltage to electronic game

ELENCO®150 Carpenter Avenue " Wheeling, IL 60090(847) 541-3800 " www.elenco.com " e-mail: [email protected]: 1) XR-2206; 2) A

PARTS LISTIf any parts are missing or damaged, see instructor or bookstore. DO NOT contact your place of purchase asthey will not be able to help you.

-2-PARTS VERIFICATIONBefore beginning the assembly process, familiarize yourself with the components and this instruction book.Verify tha

-3-INTRODUCTIONAssembly of your FG-600 Function Generator will prove to be an exciting project and give much satisficationand personal achievement.

-4-CONSTRUCTIONSolderSoldering IronFoilSolderSoldering IronFoilComponent LeadSoldering IronCircuit BoardFoilRosinSoldering iron positionedincorrectl

-5-Assemble Surface Mount ComponentsThe most important factor in assembling your FG-600 Function Generator Kit is good soldering techniques.

ASSEMBLE COMPONENTS TO THE PC BOARDCare must be given to identifying the proper components and in good soldering habits. Refer to the solderingtips se

-7-ASSEMBLE COMPONENTS TO THE PC BOARDFigure DElectrolytic capacitors havepolarity. Be sure to mount themwith the negative (–) lead(marked

-8-WIRING (See Figure J)! Solder the wire from hole J1 on the PC board tothe first yellow binding post as shown.! Solder the wire from hole J2 on the