Elenco 3 1/2 Digit with Temperature Manuale Utente Scaricare il pdf (Pagina 22)

1. To measure resistance, turn on the meter, then set up the meter

as shown in Figure 10.

2. Insert the black test lead into the COM terminal and the red test

lead into the terminal.

3. Set the Function Rotary Switch to the position (then,

“AUTO” “OL” and “MΩ” symbols are indicated on the display).

4. Connect the test leads to both ends of the resistance under test,

then the measured value is shown on the display.

Keep the following in mind when measuring resistance:

• Because the meter’s test current flows through all possible paths

between the probe tips, the measured value of a resistor in a

circuit is often different from the resistor’s rated value.

• The test leads can add 0.1Ω to 0.2Ω of error to resistance

measurements. To test the leads, touch the probe tips together

and read the resistance of the leads. If necessary, you can press

the REL

∆∆

button to automatically subtract its value.

Figure 10. Resistance Measurement

-22-

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Nessun commento

Elenco 3 1/2 Digit with Temperature Manuale Utente Pagina 22