Elenco Bigshot Camera Manuale Utente

Ages 8 - 108 yearsInstruction ManualBuild . Learn . Usewww.bigshotcamera.com

8 9After you have attached the lens wheel, try gently rotating it in each direction. It should snap into each of the three lens settings.Place the len

10 11Take the LED flash module and insert it into the PCB module. The flash module can be inserted in only one orientation. Make sure that you match and

10 11Camera PartsFront of the CameraBack of the Camera1. Shoot button2. Hand crank3. Mode dial4. Timer LED5. Lens wheel6. LED flash7. Reg

12 13Connect the camera to your PC/Mac using the USB cable provided. Do not use force or attempt to insert the connectors at an angle.The power indica

12 13Please download Bigshot software from:www.bigshotcamera.comBigshot SoftwareUseC

P38-EL362-81001000Build . Learn . Usewww.bigshotcamera.comScienceTech is a registered trademark of Edu-Science (H.K.) Ltd.Bigshot is a registered trad

1BuildSafetyUseP.2P.3P.5P.8P.10P.11P.12P.13AGetting StartedBPower GeneratorCABCElectronicsDLens WheelELED FlashCamera PartsCharging the BatteryBigshot

1Always ensure that the camera is operated according to the instructions below, which are intended to prevent injuries to yourself and other persons,

2 3Slide gear A into the hole on the side of the camera body. The blue arrow tells you the direction in which to slide the gear.Place gear C next to t

4 5Push the axel rod from the left all the way so that it enters the hole in the camera body on the right.Place the bracket on the dynamo so that it s

4 5Rotate the hand crank clockwise. If it does not rotate smoothly, one of the parts of the gearbox may be misaligned. Carefully undo the previous ste

67Pick up the PCB module and turn the mode knob to the position shown above.Fasten the PCB module onto the camera body using three screws.Now set the

67Place the connectors from the dynamo and the battery into the space at the bottom of the camera body. Make sure that the wires do not touch the gear